View source for Videoteam/CheatSheets/TwinPact

__NOTOC__
== Input selection ==

The input signal can be selected using a button on the twinpact and should always be set to RGB. The current input is indicated using a led on the device.

== Zoom ==

If you don't see the border of the image in dvswitch (but the missing part is visible on the beamer), you should press the 100% button on the remote.

== Overscan ==

'''Overscan only works with screen res 1024x768''' -- thanks to dererk for finding this out -- please make sure that the presenter's laptop is outputting in this mode!

By default when the twinpact sees a new video mode, it starts in overscan mode. This means that it will scan an area bigger than the actual display size and send it to the DV output. This is due to the composite video functionality - and ensures that the picture remains in the title safe area. However, as we are using it to convert to DV at Debconf, and are using the whole picture, the overscan behavior is undesirable - it leaves black margins around the grabbed image, which make the images weird to look at with Picture in Picture functionality. When the speaker's laptop is connected initially, the state of this function should be checked and set to '''full frame scan mode'''.

{|
|-style="vertical-align:top"
||[[Image:Overscan.png|350px]]||
To switch between overscan and full frame scan, the "overscan" button on the remote control must be pressed. This toggles between overscan and full frame scan, the two possible states. The frame on the left demonstrates the Twinpact in normal scan mode. '''This is what it should look like'''.
|}



{|
|-style="vertical-align:top"
||[[Image:Etch-n-half - Supporting new hardware within stable Andreas Barth-2.png|350px]]||
The image on the left demonstrates the Twinpact in overscan mode, '''what we want to avoid'''. In both of cases the brightness should also have been increased - the capture brightness was far too low in both.
|}


[[Category:Videoteam]]